Ford 2003 Mustang Workshop Manual page 142

5. Remove the nuts, bolt and the front suspension camber adjusting plate.
6. Raise the front end. Position the strut and spring assembly out of the way. For additional
information, refer to
7. Cut slots perpendicular to the existing camber adjustment slots.
Moving the top of the front shock absorber toward the rear of the vehicle will increase the
caster reading for that side.
Each millimeter of adjustment should yield approximately 0.12 degree of caster change.
Do not cut slots any longer than 5 mm (0.2 in.) in any direction.
Remove any burrs.
Clean and paint any exposed metal.
8. Position the strut and spring assembly. Lower the front end.
9. Install the front suspension camber adjustment plate, bolt and nuts. Hand tighten the bolt and
nuts.
Section 100-02 .