Ford 2003 Mustang Workshop Manual page 221

5. Connect the toe link to the knuckle.
1. Position the toe link in the knuckle.
2. Install a new nut.
3. Install a new cotter pin.
6. CAUTION: Make sure the hardened washer is installed between the lower
suspension arm and bushing and the shock absorber. Failure to do so can result in
damage and failure of the lower suspension arm and bushing.
Connect the shock absorber to the lower suspension arm and bushing and install the bolt and a
new nut.
7. Raise the suspension until the shock absorber is compressed to the previously established
alignment mark (curb height).