Ford 2003 Mustang Workshop Manual page 258

Hide thumbs Also See for 2003 Mustang:

Table of Contents

SECTION 204-04: Wheels and Tires

GENERAL PROCEDURES

Professional Choke and

Linkage Cleaner

F8AZ-19520-AB

Aluminum Wheel Repair

WARNING: Wheel repairs that use welding or peening are not approved. An inner tube is

not an acceptable repair for leaking wheels or tires.

If the air pressure in a tire mounted on an aluminum wheel is found to be low, perform the

following procedure before considering installation of a new wheel.

1. Remove the tire and wheel assembly, and inspect the wheel for structural damage. If none

exists, go to Step 2. If the wheel is damaged, install a new wheel.

2. With the tire mounted on the wheel, locate the air leak using a water bath or equivalent method,

and mark the location. Check the complete wheel for possible additional leaks. When leaks are

marked, dismount the tire marking valve location on the tire for correct indexing.

3. On the tire side of the wheel, thoroughly clean the leaking area with an appropriate choke

cleaner or use sandpaper of approximately 80-grit to remove all contamination. Using the

sandpaper, score the surface of the leaking area to improve adhesion of the sealer. If the valve

stem is close to the area, remove it.

4. Use a clean cloth to remove all cleaner or sanding dust.

5. NOTE: Do not use a torch containing oxyacetylene.

Heat the prepared area with a Heat Gun or a propane torch until aluminum wheel repair

compound flows. Apply the hot melt material over the prepared area using a liberal flow and

wiping action. Repair is most effective when heat is applied to the brake side of the rim, and the

sealer is melted by heat in the metal.

6. Apply only enough heat to melt the sealer, then remove the heat source. After repairing the

leak, allow the wheel to cool until it can be handled safety.

CAUTION: Use caution when mounting the tire so as not to damage the sealer.

Index and assemble the tire and wheel. Inflate the tire to the recommended pressure as

indicated on the tire pressure decal.

8. Repeat Step 2 to verify repair.

9. When the repair is completed, balance the assembly and install it on the vehicle.

Specification

2003 Mustang Workshop Manual

Show Quick Links

Table of Contents