Ford 2003 Mustang Workshop Manual page 293

SECTION 205-01: Driveshaft
REMOVAL AND INSTALLATION
Driveshaft
Material
Item
Threadlock® and
Sealer
E0AZ-19554-AA
Removal and Installation
1. Raise and support the vehicle. For additional information, refer to
2. Carry out the following:
1. Place an index mark on the rear axle pinion flange and the driveshaft centering socket
yoke.
2. Remove the four bolts.
3. CAUTION: The driveshaft centering socket yoke fits tightly on the rear axle pinion
flange pilot. Never hammer on the driveshaft or any of its components to disconnect the
yoke from the flange. Pry only in the area shown, with a suitable tool, to disconnect the
yoke from the flange.
Using a suitable tool as shown, disconnect the driveshaft centering socket yoke from the rear
axle pinion flange.
4. CAUTION: Do not allow the slip yoke to bottom on the transmission output shaft.
Specification
WSK-M2G351-A5 (type
II)
2003 Mustang Workshop Manual
Section 100-02 .