Ford 2003 Mustang Workshop Manual page 155

SECTION 204-01: Front Suspension
REMOVAL AND INSTALLATION
Wheel Hub and Bearing
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number or an equivalent part must be installed, if installation is necessary. Do
not use a part of lesser quality or substitute design. Torque values must be used as specified
during reassembly to ensure correct retention of these parts.
1. Raise the vehicle on a hoist. For additional information, refer to
2. Remove the wheel and tire assembly. For additional information, refer to
3. Remove the front brake disc. For additional information, refer to
4. Remove and discard the front hub cap grease seal (1N135).
5. CAUTION: The wheel hub retainer (3B477) is a one time use item and must be
replaced with a new retainer when removed. Failure to do so can cause the retainer to
come loose during vehicle operation resulting in loss of vehicle control.
Remove and discard the front axle wheel hub retainer.
6. Remove the front wheel hub and bearing (1104).
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04
Section 206-03 .
.