Ford 2003 Mustang Workshop Manual page 177

SECTION 204-01: Front Suspension
REMOVAL AND INSTALLATION
Spring
Special Tool(s)
Tie-Rod End Remover
211-001 (TOOL-3290-D) or
Equivalent
Coil Spring Compressor
204-D001 (D78P-5310-A) or
Equivalent
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number or an equivalent part must be installed, if installation is necessary. Do
not use a part of lesser quality or substitute design. Torque values must be used as specified
during reassembly to ensure proper retention of these parts.
1. Mark the front shock absorber (18124) relative to the protective sleeve with the vehicle in a
static, level ground position (curb height).
2. Raise the vehicle on a hoist. For additional information, refer to
3. Remove the wheel and tire assembly. For additional information, refer to
4. Remove the cotter pin and nut. Discard the cotter pin.
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04 .