Ford 2003 Mustang Workshop Manual page 303

6. Remove the driveshaft flange yoke.
1. Position the driveshaft flange yoke in the U-joint tool.
2. Press out a bearing cup.
3. Remove the driveshaft flange yoke.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the driveshaft flange yoke.
7. Remove the spider.
1. Reposition the driveshaft in the U-joint tool.
2. Press out the bearing cup.
3. Rotate the driveshaft.
4. Press on the spider to remove the remaining bearing cup.
5. Remove the spider.
8. Clean the yoke area at the end of the driveshaft.
Assembly
1. NOTE: Universal joint kits are to be installed as complete assemblies only. Do not mix
components from other U-joint kits.
Install the spider.
1. Start a new bearing cup into the driveshaft yoke.
Check the needle bearings for correct positioning.