Ford 2003 Mustang Workshop Manual page 157

SECTION 204-01: Front Suspension
REMOVAL AND INSTALLATION
Arm —Lower
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number or an equivalent part must be installed, if installation is necessary. Do
not use a part of lesser quality or substitute design. Torque values must be used as specified
during reassembly to ensure correct retention of these parts.
1. Mark the front shock absorber (18124) relative to the protective sleeve with the vehicle in a
static, level ground position (curb height).
2. Raise the vehicle on a hoist. For additional information, refer to
3. Remove the wheel and tire assembly. For additional information, refer to
4. Remove the front brake disc shield. For additional information, refer to
5. CAUTION: To prevent damage to the front suspension lower arm (3078) do not
remove the nut from the ball joint (3050) at this time.
Disconnect the ball joint stud from the arm.
Loosen the nut two or three turns.
Sharply rap on the front wheel spindle (3105) at the ball joint connection to disconnect
the ball joint stud.
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04
Section 206-03
.
.