Ford 2003 Mustang Workshop Manual page 225

SECTION 204-02: Rear Suspension
REMOVAL AND INSTALLATION
Toe Link —Cobra
Special Tool(s)
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number must be installed if installation becomes necessary. If substitution is
necessary, the part must be of the same finish and property class. Torque values must be used
as specified during reassembly to make sure of correct retention of these parts.
1. Raise the vehicle on a hoist. For additional information, refer to
2. Remove the wheel and tire assembly. For additional information, refer to
3. Remove the rear brake disc. For additional information, refer to
4. Support the lower suspension arm and bushing (5A649) with a jack stand.
5. Remove the nut and bolt and disconnect the shock absorber (18125) from the lower suspension
arm and bushing. Discard the nut and bolt.
6. Remove and discard the cotter pin and nut.
Steering Arm Remover
211-003 (T64P-9171-A)
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04
Section 206-04 .
.