Ford 2003 Mustang Workshop Manual page 333

Hide thumbs Also See for 2003 Mustang:

Table of Contents

Check that the cups have seated correctly in their bores.

Using special tools 205-153, 205-054, and 205-D055

NOTE: This is an alternate method for installing the pinion bearing cups. Carry out this procedure if

pinion bearing cup installation was not done in the previous steps.

4. Using the special tools, drive the outer differential drive pinion bearing cup (4616) into the

differential housing.

5. Using the special tools, drive the inner rear axle pinion bearing cup (4628) into the differential

CAUTION: Always install new differential pinion bearings when installing new

pinion bearing cups.

NOTE: If the feeler gauge can fit between a cup and the bottom of its bore at any point around

the cup, remove and reseat the cup.

Check that the cups have seated correctly in their bores.

Show Quick Links

Table of Contents