Ford 2003 Mustang Workshop Manual page 140

SECTION 204-00: Suspension System — General Information
GENERAL PROCEDURES
Wheel Bearing Inspection
1. Raise the vehicle until the tire is off the floor. For additional information, refer to
2. NOTE: Make sure the wheel rotates freely and the brake pads are retracted sufficiently to allow
movement of the tire and wheel assembly.
Grasp each tire at the top and bottom and move the wheel inward and outward while lifting the
weight of the tire off the wheel bearing.
3. If the tire and wheel (hub) is loose on the wheel spindle or does not rotate freely, install a new
front wheel hub (1104) as necessary. For additional information, refer to
2003 Mustang Workshop Manual
Section 100-02
Section 204-01
.
.