Ford 2003 Mustang Workshop Manual page 195

SECTION 204-02: Rear Suspension
REMOVAL AND INSTALLATION
Wheel Studs
Special Tool(s)
C-Frame and Clamp Assembly
211-023 (T74P-3044-A1)
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number must be installed if installation becomes necessary. If substitution is
necessary, the part must be of the same finish and property class. Torque values must be used
as specified during reassembly to make sure of correct retention of these parts.
1. Raise the vehicle on a hoist. For additional information, refer to
2. Remove the wheel and tire assembly. For additional information, refer to
3. Remove the rear brake disc. For additional information, refer to
4. Using the special tool, remove and discard the wheel stud.
Installation
CAUTION: Do not use air tools to install the wheel stud. The serrations in the hub flange
can be stripped.
1. Install the wheel stud.
1. Position a new wheel stud in the hub flange making sure the serrations on the stud line
up with the serrations in the flange.
2. Position washers and a reversed wheel nut on the wheel stud.
3. Tighten the wheel nut until the wheel stud seats on the back of the hub flange.
2003 Mustang Workshop Manual
Section 100-02 .
Section 204-04
Section 206-04 .
.