Ford 2003 Mustang Workshop Manual page 197

SECTION 204-02: Rear Suspension
REMOVAL AND INSTALLATION
Upper Arm
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital
components and systems and their failure can result in major service expense. A new part with
the same part number must be installed if installation becomes necessary. If substitution is
necessary, the part must be of the same finish and property class. Torque values must be used
as specified during reassembly to make sure of correct retention of these parts.
1. Mark the rear shock absorber (18125) relative to the protective sleeve with the vehicle in a
static, level ground position (curb height).
2. Raise the vehicle on a hoist. For additional information, refer to
3. Support the differential housing with a jack stand.
4. Disconnect the upper arm and bushing (5500) from the axle.
1. Remove and discard the nut and bolt.
2. Disconnect the arm and bushing from the axle.
5. Remove the upper arm and bushing from the mounting bracket.
1. Remove and discard the nut and bolt.
2. Remove the arm and bushing.
2003 Mustang Workshop Manual
Section 100-02 .