Ford 2003 Mustang Workshop Manual page 879

SECTION 303-00: Engine System — General Information
GENERAL PROCEDURES
Crankshaft Runout
Special Tool(s)
Dial Indicator Gauge with
Holding Fixture
100-002 (TOOL-4201-C) or
equivalent
1. NOTE: Crankshaft main bearing journals must be within specifications before checking runout.
Use the Dial Indicator Gauge with Holding Fixture to measure the crankshaft runout.
Refer to the appropriate section in Group
Rotate the crankshaft and subtract the lowest dial indicator reading from the highest dial
indicator reading to figure the crankshaft runout. If it is out of specification, install new
components as necessary. Refer to the appropriate section in Group
procedure.
2003 Mustang Workshop Manual
303 for the procedure.
303 for the