Is the battery voltage between 10 and 13 volts with KOEO, and
between 11 and 17 volts with the engine running?
C2 CHECK THE VOLTAGE TO THE ANTI-LOCK BRAKE CONTROL
MODULE
Key in OFF position.
Disconnect: Anti-Lock Brake Control Module C141.
Key in ON position.
Measure the voltage between anti-lock brake control module C141
Pin 8, Circuit 601 (LB/PK), harness side and ground.
Is the voltage greater than 10 volts?
C3 CHECK THE ANTI-LOCK BRAKE CONTROL MODULE GROUNDS
Measure the resistance between anti-lock brake control module
C141 Pin 12, Circuit 1205 (BK), harness side and ground; and
between anti-lock brake control module C141 Pin 15, Circuit 397
(BK/WH), harness side and ground.
Are the resistances less than 5 ohms?
PINPOINT TEST D: DTC B1484, BRAKE PEDAL INPUT OPEN
CIRCUIT
D1 CHECK THE STOPLAMPS FOR CORRECT OPERATION
Test Step
414-00
.
Yes
GO to
C3
.
No
REPAIR the circuit.
CLEAR the DTCs.
REPEAT the self-
test.
Yes
INSTALL a new
anti-lock brake
control module;
REFER to
Module
REPEAT the self-
test.
No
REPAIR the circuit
in question.
CLEAR the DTCs.
REPEAT the self-
test.
Result / Action to Take
.