Ford 2003 Mustang Workshop Manual page 412

17. Remove the axle from the vehicle.
18. CAUTION: Align the index marks on the driveshaft centering socket yoke and the
pinion flange.
CAUTION: Install the driveshaft with new bolts. If new bolts are not available, apply
Threadlock and Sealer EOAZ-19554-AA or equivalent meeting Ford specification WSK-
M2G351-A5 to the threads of the original bolts.
CAUTION: The driveshaft centering socket yoke fits tightly on the pinion flange
pilot. To make sure that the yoke seats squarely on the flange, tighten the bolts evenly in
a cross pattern as shown.
CAUTION: Raise the suspension to the reference marks on the rear shock
absorbers before tightening the suspension fasteners.
NOTE: Apply High Temperature Nickel Anti-Sieze Lubricant F6AZ-9L494-AA meeting Ford
specification ESE-M124A-A to the rear anti-lock brake sensor body where it will make contact
when installed.
Follow the removal procedure in reverse order.
Refer to Section 204-02
Refer to Section 204-04
for rear suspension fastener tightening specifications.
for wheel nut tightening specification.