Grandstream Networks UCM6510 User Manual page 93

Upgrade via
Server Path
File Prefix
File Postfix
Allow DHCP Option 43/66
Automatic Upgrade
Firmware Upgrade Rule
Web Access
Admin Password
End-­User Password
Web A ccess Mode
Web Server Port
Security
Disable Telnet/SSH
Firmware Version 1.0.2.5
"ZC_firmware" in the USB storage root directory.
Local SD Card Media
•
If selected, an SD card needs to be plugged into the UCM6510 and
the firmware file must be put under a folder named "ZC_firmware" in
the USB storage root directory.
When URL is selected as firmware source, configure upgrade via TFTP,
HTTP or HTTPS.
When URL is selected as firmware source, configure the firmware
upgrading server path.
When URL is selected as firmware source, configure the firmware file
prefix. If configured, only the firmware with the matching encrypted prefix
will be downloaded and flashed into the phone, if URL is selected as
firmware source.
When URL is selected as firmware source, configure the firmware file
postfix. If configured, only the configuration file with the matching
encrypted postfix will be downloaded and flashed into the phone.
If DHCP option 43 or 66 is enabled on the LAN side, the TFTP server can
be redirected.
If enabled, the end point device will automatically upgrade if a new
firmware is detected. Users can select automatic upgrading by day, by
week or by minute.
By week
•
Once selected, specify the day of the week to check HTTP/TFTP
server for firmware upgrades or configuration files changes.
By day
•
Once selected, specify the hour of the day to check the HTTP/TFTP
server for firmware upgrades or configuration files changes.
By minute
•
Once selected, specify the interval X that the SIP end device will
request for new firmware every X minutes.
Specify how firmware upgrading and provisioning request to be sent.
Configure the administrator password for admin level login.
Configure the end-­user password for the end user level login.
Select HTTP or HTTPS as the web access protocol.
Configure the port for web access. The valid range is 1 to 65535.
Enable Telnet/SSH access for the SIP end device. If the SIP end device
UCM6510 IP PBX User Manual Page 92 of 317