Model Update; Device Configuration; Create New Device; Figure 61: Template Management - Grandstream Networks UCM6510 User Manual

MODEL U PDATE
UCM6510 zero config feature supports provisioning all models of Grandstream SIP end devices.
Templates for most of the Grandstream models are built in with the UCM6510 already. Templates for
GXP16XX, GSWave and Surveillance products requires user to download on UCM6510 web
UI-­>PBX-­>Zero Config-­>Model Update first as those products are more often used as needed. After
downloading the model template, it will show in the dropdown list for "Model" selection when editing the
model template.
Click on to download the template.
•
User could also upload model template package to UCM6510.
•
DEVICE C ONFIGURATION
On web GUI, page PBX-­>Zero Config-­>Zero Config, users could create new device, delete existing
device(s), make special configuration for a single device, or send NOTIFY to existing device(s).
CREATE N EW D EVICE
Besides configuring the device after the device is discovered, users could also directly create a new device
and configure basic settings before the device is discovered by the UCM6510. Once the device is plugged
in, it can then be discovered and provisioned. This gives the system administrator adequate time to set up
each device beforehand.
Click on "Create New Device" and the following dialog will show. Follow the steps below to create the
configurations for the new device.
Firmware Version 1.0.2.5
Figure 61: Template Management
UCM6510 IP PBX User Manual Page 99 of 317