Call Routes; Outbound Routes; Table 63: Outbound Route Configuration Parameters - Grandstream Networks UCM6510 User Manual

OUTBOUND R OUTES
In the UCM6510, an outgoing calling rule pairs an extension pattern with a trunk used to dial the pattern.
This allows different patterns to be dialed through different trunks (e.g., "Local" 7-­digit dials through a FXO
while "Long distance" 10-­digit dials through a low-­cost SIP trunk). Users can also set up a failover trunk to
be used when the primary trunk fails.
Go to web GUI-­>PBX-­>Basic/Call Routes-­>Outbound Routes to add and edit outbound rules.
Click on "Create New Outbound Rule" to add a new outbound route.
•
Click on to edit the outbound route.
•
Click on to delete the outbound route.
•
On the UCM6510, the outbound route priority is based on "Best matching pattern". For example, the
•
UCM6510 has outbound route A with pattern 1xxx and outbound route B with pattern 10xx configured.
When dialing 1000 for outbound call, outbound route B will always be used first. This is because
pattern 10xx is a better match than pattern 1xxx. Only when there are multiple outbound routes with
the same pattern configured, users can click on
arrange the priority among those outbound routes.
Calling Rule Name
Pattern
Password
Call Duration Limit
Firmware Version 1.0.2.5
CALL R OUTES
Table 63: Outbound Route Configuration Parameters
Configure the name of the calling rule (e.g., local, long_distance, and etc).
Letters, digits, _ and -­ are allowed.
All patterns are prefixed with the "_".
•
Special characters:
•
X: A ny Digit from 0-­9.
Z: A ny Digit from 1-­9.
N: A ny Digit from 2-­9.
".": Wildcard. Match one or more characters.
"!": Wildcard. Match zero or more characters immediately.
Example: [12345-­9] -­ A ny digit from 1 to 9.
Configure the password for users to use this rule when making outbound
calls.
Once call duration limit is enabled, it will set the maximum duration of
call-­blocking.
UCM6510 IP PBX User Manual
to move the outbound route up/down to
Page 180 of 317