Network Settings; Basic Settings; Table 8: Ucm6510 Network Settings-­>Basic Settings - Grandstream Networks UCM6510 User Manual

Enter the password of
the account
Email A ddress
NETWORK S ETTINGS
After successfully connecting the UCM6510 to the network for the first time, users could log in the web GUI
and go to Settings-­>Network Settings to configure the network parameters for the device. Select each
tab in web GUI-­>Settings-­>Network Settings page to configure LAN/WAN settings, 802.1X and Port
Forwarding.
Note:
To connect the UCM6510 to network, T1/E1/J1 data trunk can also be used, instead of using the
WAN/LAN port. Please see section
Internet.
BASIC S ETTINGS
Please refer to the following tables for basic network configuration parameters on the UCM6510.
Method
Preferred DNS Server
WAN (when "Method" is set to "Route")
IP Method
Firmware Version 1.0.2.5
Enter the current login user credential for UCM6510
Email A ddress is used to retrieve password when password is lost
[DATA TRUNK]
Table 8: UCM6510 Network Settings-­>Basic Settings
Select "Route", "Switch" or "Dual" mode on the network interface of UCM6510. The
default setting is "Route".
Route
•
WAN port interface will be used for uplink connection. LAN port interface will be
used to serve as router.
Switch
•
WAN port interface will be used for uplink connection. LAN port interface will be
used as bridge for PC connection.
Dual
•
Both ports can be used for uplink connection. Users will need assign LAN 1 or
LAN 2 as the default interface in option "Default Interface" and configure
"Gateway IP" for this interface if static IP is used for the interface.
Enter the preferred DNS server address. If Preferred DNS is configured, the
UCM6510 will use it as Primary DNS server.
Select DHCP, Static IP, or PPPoE. The default setting is DHCP.
UCM6510 IP PBX User Manual
to use UCM6510 data trunk to connect the device to
Page 45 of 317