Source Channel
Destination Channel
Destination Number
Note:
The PSTN detection process will keep the call up for about 1 minute.
•
If "Semi-auto Detect' is used, please pick up the call only after informed from the web GUI prompt.
•
Once the detection is successful, the detected parameters "Busy Tone", "Polarity Reversal" and
"Current Disconnect by PSTN" will be filled into the corresponding fields in the analog trunk
configuration.
ANALOG
H ARDWARE
C ONFIGURATION
The analog hardware (FXS port and FXO port) on the UCM6510 can be configured under web
GUI->PBX->Ports Config->Analog Hardware. Click on
configure A CIM settings for FXO port.
Select "Loop Start" or "Kewl Start" for each FXS port. A nd then click on "Update" to save the change.
Firmware Version 1.0.2.5
detection, source channel will be used as caller and send the call to
the configured Destination Number. Users will then need follow the
prompts in web GUI to help finish the detection.
The default setting is "Auto Detect".
Select the channel to be detected.
Select the channel to help detect when "Auto Detect" is used.
Configure the number to be called to help the detection.
Figure 85: FXS Ports Signaling Preference
UCM6510 IP PBX User Manual
to edit signaling preference for FXS port or
Page 144 of 317