Internal  Options; Internal  Options/General; Table  82:  Internal  Options/General - Grandstream Networks UCM6510 User Manual

Ip pbx
Hide thumbs Also See for UCM6510:
Table of Contents

Advertisement

 
This  section  describes  internal  options  that  haven't  been  mentioned  in  previous  sections  yet.  The  settings  
in  this  section  can  be  applied  globally  to  the  UCM6510,  including  general  configurations,  jitter  buffer,  RTP  
settings,  hardware  config  and  STUN  monitor.  The  options  can  be  accessed  via  web  GUI-­>PBX-­>Internal  
Options.  
 
INTERNAL   O PTIONS/GENERAL  
General  Preferences  
Global  OutBound  CID  
Global  OutBound  CID  Name  
Operator  Extension  
Ring  Timeout  
Record  Prompt  
Extension  Preferences  
Enforce  Strong  Passwords  
Firmware  Version  1.0.2.5  
 
INTERNAL   O PTIONS  
 
Table  82:  Internal  Options/General  
Configure   the   global   CallerID   used   for   all   outbound   calls   when   no   other  
CallerID   is   defined   with   higher   priority.   If   no   CallerID   is   defined   for  
extension  or  trunk,  the  global  outbound  CID  will  be  used  as  CallerID.  
Configure   the   global   CallerID   Name   used   for   all   outbound   calls.   If  
configured,  all  outbound  calls  will  have  the  CallerID  Name  set  to  this  name.  
If  not,  the  extension's  CallerID  Name  will  be  used.  
Specify  the  operator  extension,  which  will  be  dialed  when  users  presses  0  
to  exit  voicemail  application.  The  operator  extension  can  also  be  used  in  
IVR  option.  
Configure  the  number  of  seconds  to  ring  an  extension  before  the  call  goes  
to  the  user's  voicemail  box.  The  default  setting  is  60.    
 
Note:  
This  is  the  global  value  used  for  each  extension  if  "Ring  Timeout"  field  is  
left  empty  on  the  extension  configuration  page.      
If   enabled,   users   will   hear   voice   prompt   before   recording   is   started   or  
stopped.   For   example,   before   recording,   the   UCM6510   will   play   voice  
prompt  "The  call  will  be  recorded".  The  default  setting  is  "No".  
If  enabled,  strong  password  will  be  enforced  for  the  password  created  on  
the  UCM6510.  The  default  setting  is  enabled.  
 
Strong  Password  Rules:  
1.   Password   for   voicemail,   voicemail   group,   outbound   route,   DISA,   call  
queue   and   conference   requires   non-­repetitive   and   non-­sequential  
digits,  with  a  minimum  length  of  4  digits.  Repetitive  digits  pattern  (such  
UCM6510  IP  PBX  User  Manual  
 
 
Page  256  of  317

Advertisement

Table of Contents
loading

Table of Contents