Grandstream Networks UCM6510 User Manual page 170

Keep Original CID
Keep Trunk CID
NAT
Disable This Trunk
TEL URI
Caller ID
CallerID Name
Auto Record
Advanced Settings
Firmware Version 1.0.2.5
All -­ TCP Primary: TCP is the primary transport protocol when all the
•
other SIP transport methods are available too.
All – TLS Primary: TLS is the primary transport protocol when all the
•
other SIP transport methods are available too.
Keep the CID from the inbound call when dialing out, this setting will
override "Keep Trunk CID" option. Please make sure that the peer PBX at
the other side supports to match user entry using "username" field from
authentication line.
If enabled, the trunk CID will not be overridden by extension's CID when
the extension has CID configured. The default setting is "No".
Turn on this option when the PBX is using public IP and communicating
with devices behind NAT. If there is one-­way audio issue, usually it's
related to NAT configuration or SIP/RTP port configuration on the firewall.
If selected, the trunk will be disabled.
Note:
If a current SIP trunk is disabled, UCM6510 will send UNREGISTER
message (REGISTER message with expires=0) to the SIP provider.
If the trunk has an assigned PSTN telephone number, this field should be
set to "User=Phone". Then a "User=Phone" parameter will be attached to
the Request-­Line and TO header in the SIP request to indicate the E.164
number. If set to "Enable", "Tel:" will be used instead of "SIP:" in the SIP
request. The default setting is disabled.
Configure the Caller ID. This is the number that the trunk will try to use
when making outbound calls. For some providers, it might not be possible
to set the CallerID with this option and this option will be ignored.
When making outgoing calls, the following rules are used to determine
which CallerID will be used if they exist:
The CallerID configured for the extension will be looked up first.
•
If no CallerID configured for the extension, the CallerID configured for
•
the trunk will be used.
If the above two are missing, the "Global Outbound CID" defined in
•
Web GUI-­>PBX-­>Internal Options-­>General will be used.
Configure the name of the caller to be displayed when the extension has
no CallerID Name configured.
Enable automatic recording for the calls using this trunk (for SIP trunk
only). The default setting is disabled. The recording files can be accessed
under web GUI-­>CDR-­>Recording Files.
UCM6510 IP PBX User Manual Page 169 of 317