Digital Trunks; Digital Hardware Configuration; Figure 87: Digital Hardware Configuration - Grandstream Networks UCM6510 User Manual

The UCM6510 supports E1/T1/J1 which are physical connection technology used in digital network. T1 is
the North A merican standard, J1 is used in Japan, whereas E1 is the European standard.
UCM6510 supports four signaling protocols: PRI, MFC/R2, SS7, E&M Immediate and E&M Wink. PRI
provides a varying number of channels depending on the standards in the country of implementation (E1,
T1 or J1);; MFC/R2 is a signaling protocol heavily used over E1 trunks;; SS7 uses out-­of-­band signaling,
which travels on a separate, dedicated channel rather than within the same channel as the telephone call,
providing more efficiency and higher security level when the telephone calls are set up. E&M Immediate
and E&M Wink are only valid when using T1 port.
To set up digital trunk on the UCM6510:
1. Go to web UI-­>PBX-­>Ports Config-­>Digital Hardware to configure port type and channels.
2. Go to web UI-­>PBX-­>Basic/Call Routes-­>Digital Trunks to add and edit digit trunk.
3. Go to web UI-­>PBX-­>Basic/Call Routes-­>Outbound Routes and Inbound Routes to configure
outbound and inbound rule for the digital trunk.
DIGITAL H ARDWARE C ONFIGURATION
Go to web GUI-­>PBX-­>Ports Config-­>Digital Hardware page and configure the following:
Step 1: Click on
•
Step 2: Click on
•
channels can be assigned to the default group;; for T1/J1, 23 B channels can be assigned to the default
group.
Step 3: If fewer than 30 B channels for E1 or 23 B channels for T1/J1 are assigned in default group,
•
users can click on
Firmware Version 1.0.2.5
DIGITAL T RUNKS
Figure 87: Digital Hardware Configuration
to edit digital ports. Please see configuration parameters in the tables below.
to edit group. This assigns channels to be used for the digital port. For E1, 30 B
to add more groups. This is not necessary in most cases and only default
UCM6510 IP PBX User Manual
3
1
2
Page 148 of 317