Model Configuration; Table 30: Create New Model Template - Grandstream Networks UCM6510 User Manual

MODEL C ONFIGURATION
MODEL T EMPLATES
Model layer configuration allows users to apply model-­specific configurations to different devices. Users
could create/edit/delete a model template by accessing web GUI, page PBX-­>Zero Config-­>Model
Templates. If multiple model templates are created and enabled, when the user configures the device in
Edit Device dialog-­>Advanced Settings, the user can select to use one of the model template for the
device. Please refer to section
For each created model template, users can assign it as default model template. If assigned as default
model template, the values in this model template will be applied to all the devices of this model. There is
always only one default model template that can be assigned at one time on the UCM6510.
The selected model template and the default model template will both take effect when generating the
config file for the device. However the model template has higher priority to default model template when it
comes to the same setting option/field. If the same option/field has different value configured in the default
model template and the selected model template, the value for this option/field in the selected model
template will override the value in default model template.
Click on "Create New Template" to add a model template.
•
Model
Template Name
Description
Default Model Template
Active
Click on to edit the model template.
•
The editing window for model template is shown in the following figure. In the "Options" field, enter the
option name key word, the option that contains the key word will be listed. User could then select the
option and click on "Add Option" to add it into the model template.
Once added, the option will be shown in the list below. On the left side of each option, users can click
on to remove this option from the model template. On the right side of each option, users can click
on to reset the option to the default value.
Firmware Version 1.0.2.5
MANAGE DEVICES for more details on using the model template.
[ ]
Table 30: Create New Model Template
Select a model to apply this template. The supported Grandstream
models are listed in the dropdown list for selection.
Create a name for the model template.
Enter a description for the model template. This is optional.
Select to assign this model template as the default model template. The
value of the option in default model template will be overridden if other
selected model template has a different value for the same option.
Check this option to enable the model template.
UCM6510 IP PBX User Manual Page 97 of 317