Digital Trunk Configuration; Table 54: Digital Trunk Configuration Parameters - Grandstream Networks UCM6510 User Manual

rxwink
DIGITAL T RUNK C ONFIGURATION
After configuring digital hardware, go to web GUI-­>PBX-­>Basic/Call Routes-­>Digital Trunks.
Click on "Create New Digital Trunk" to add a new digital trunk.
•
Click on to configure detailed parameters for the digital trunk.
•
Click on to configure Direct Outward Dialing (DOD) for the digital Trunk.
•
Click on to delete the digital trunk.
•
The digital trunk parameters are listed in the table below.
Trunk Name
Channel Group
Hide CallerID
Keep Trunk CID
Caller ID
CallerID Name
Auto Record
Firmware Version 1.0.2.5
Configure receive wink timing. The default setting is 300ms.
Table 54: Digital Trunk Configuration Parameters
Configure trunk name to identify the digital trunk.
Configure the digital channel group used by the trunk.
Configure to hide outgoing caller ID. The default setting is "No".
If enabled, the trunk CID will not be overridden by extension's CID when
the extension has CID configured. The default setting is "No".
Configure the Caller ID. This is the number that the trunk will try to use
when making outbound calls. For some providers, it might not be possible
to set the CallerID with this option and this option will be ignored.
When making outgoing calls, the following rules are used to determine
which CallerID will be used if they exist:
The CallerID configured for the extension will be looked up first.
•
If "Keep Trunk CID" is enabled, the CallerID configured for the trunk
•
will be used.
If the above two are missing, the "Global Outbound CID" defined in
•
web GUI-­>PBX-­>Internal Options-­>General will be used.
Configure the new name of the caller when the extension has no CallerID
Name configured.
Enable automatic recording for the calls using this trunk (for SIP trunk
only). The default setting is disabled. The recording files are saved in
UCM6510 IP PBX User Manual Page 158 of 317