Auto Record
Skip Trunk A uth
Time Condition for Skip Trunk
Auth
Dial Trunk Password
Specific Time
Time Condition
BATCH
A DD
E XTENSIONS
BATCH
A DD
S IP
E XTENSIONS
In order to add multiple SIP extensions, BATCH add can be used to create standardized SIP extension
accounts. However, unique extension user name can't be set using BATCH add.
Under web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
SIP Extensions".
General
Start Extension
Create Number
Permission
Firmware Version 1.0.2.5
under web GUI->Internal Options->IVR Prompt: General Preference. The
valid range is between 5 seconds and 600 seconds.
Note:
If the end point also has a ring timeout configured, the actual ring timeout
used is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default
setting is disabled. The recording files can be accessed under web
GUI->CDR->Recording Files.
If set to "Yes", users can skip entering the password when making
•
outbound calls.
If set to "By Time", users can skip entering the password when
•
making outbound calls during the selected time condition.
If set to "No", users will be asked to enter the password when making
•
outbound calls.
If "Skip Trunk Auth" is set to "By Time", select a time condition during
which users can skip entering password when making outbound calls.
Configure personal password when making outbound calls via trunk.
Table 42: FXS Extension Configuration Parameters – Specific Time
Click to add Time Condition to configure specific time for this extension.
Table 43: Batch Add SIP Extension Parameters
Configure the starting extension number of the batch of extensions to be
added.
Specify the number of extensions to be added. The default setting is 5.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to the
UCM6510 IP PBX User Manual
Page 127 of 317