Create New Iax Extension; Table 34: Sip Extension Configuration Parameters - Specific Time; Table 35: Iax Extension Configuration Parameters - Basic Settings - Grandstream Networks UCM6510 User Manual

Skip Trunk A uth
Time Condition for Skip Trunk
Auth
Dial Trunk Password
Specific Time
Time Condition
CREATE N EW I AX E XTENSION
The UCM6510 supports Inter-­Asterisk eXchange (IAX) protocol. IAX is used for transporting VoIP
telephony sessions between servers and terminal devices. IAX is similar to SIP but also has its own
characteristic. For more information, please refer to RFC5465.
To manually create new IAX user, go to web GUI-­>PBX-­>Basic/Call Routes-­>Extensions. Click on
"Create New IAX Extension" and a new dialog window will show for users to fill in the extension
information. The configuration parameters are as follows.
General
Extension
CallerID Number
Permission
Firmware Version 1.0.2.5
· If set to 'yes', users can skip entering the password when making
outbound calls.
· If set to 'By Time', users can skip entering the password when making
outbound calls during the selected time condition.
· If set to 'No', users will be asked to enter the password when making
outbound calls.
If 'Skip Trunk A uth' is set to 'By Time', select a time condition during which
users can skip entering password when making outbound calls.
Configure personal password when making outbound calls via trunk.
Table 34: SIP Extension Configuration Parameters – Specific Time
Click to add Time Condition to configure specific time for this extension.
Table 35: IAX Extension Configuration Parameters – Basic Settings
The extension number associated with the user.
Configure the CallerID Number that would be applied for outbound calls
from this user.
Note:
The ability to manipulate your outbound Caller ID may be limited by your
VoIP provider.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls using this rule.
UCM6510 IP PBX User Manual Page 118 of 317