Alert Log - Grandstream Networks UCM6510 User Manual

Detect Cycle: The UCM6510 will check the system update based on this cycle. Users can enter
•
the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the cycle.
6. System Crash
Detect Cycle: The UCM6510 will detect the event at each cycle based on the specified time.
•
Users can enter the number and then select second(s)/minute(s)/hour(s)/day(s) to configure the
cycle.
Click on the switch
could also select the checkbox for each event and then click on button "Alert On", "Alert Off", "Email
Notification On", "Email Notification Off" to control the alert and Email notification configuration.
ALERT L OG
Under web GUI-­>Status-­>System Events-­>Alert Log, system messages are listed when the alert is
triggered for the configured system events. The following picture shows disk usage alert log. We can tell
the detect cycle for the disk usage is 10 minutes and the disk usage is restored to normal after the
administrator cleans up the disk storage below the threshold.
The following screenshot shows system crash alert logs.
Firmware Version 1.0.2.5
Figure 161: System Events-­>Alert Events Lists: System Update
Figure 162: System Events-­>Alert Events Lists: System Crash
to turn on/off the alert and Email notification for the event. Users
Figure 163: System Events-­>Alert Log
UCM6510 IP PBX User Manual Page 286 of 317