4. Once created, it will be displayed on the follow me web page list. Click on
configuration. Click on
The following table shows the Follow Me configuration parameters.
Enable
Skip Trunk A uth
Music On Hold Class
Confirm When A nswering
Follow Me Numbers
New Follow Me Number
Dialing Order
5. Click on "Follow Me Options" to enable or disable the options listed in the following table.
Playback Incoming Status
Message
Record the Caller's Name
Playback Unreachable Status
Message
Firmware Version 1.0.2.5
to delete the Follow Me.
Table 76: Follow Me Settings
Configure to enable or disable Follow Me for this user.
If external number is added in the Follow Me, please make sure this option
is enabled or the "Skip Trunk Auth" option of the extension is enabled,
otherwise the external Follow Me number cannot be reached.
Configure the Music On Hold class that the caller would hear while
tracking the user.
By default it is enabled and user will be asked to press 1 to accept the call
or to press 2 to reject the call after answering a Follow Me call.
If it is disabled, the Follow Me call will be established once after the user
answers it.
The added numbers are listed here. Click on
Click on
to delete the number. Click on
Add a new Follow Me number which could be a 'Local Extension' or
'External Number'. The selected dial plan should have permissions to dial
the defined external number.
Select the order in which the Follow Me destinations will be dialed to reach
the user: ring all at once or ring one after the other.
Table 77: Follow Me Options
If enabled, the PBX will playback the incoming status message before
starting the Follow Me steps.
If enabled, the PBX will record the caller's name from the phone so it can
be announced to the callee in each step.
If enabled, the PBX will playback the unreachable status message to the
caller if the callee cannot be reached.
UCM6510 IP PBX User Manual
to edit the Follow Me
to arrange the order.
to add new numbers.
Page 231 of 317
Need help?
Do you have a question about the UCM6510 and is the answer not in the manual?