From User
Send PPI Header
Send PAI Header
Outbound Proxy Support
Outbound Proxy
DID Mode
DTMF Mode
Enable Qualify
Qualify Timeout
Firmware Version 1.0.2.5
Configure the actual user name of the extension. This can be used to
override the From Header. There are cases where there is a single ID for
registration (single trunk) with multiple DIDs.
For example, "1234567" is the From User in From Header:
sip:1234567@trunk.UCM6510.provider.com.
If enabled, the SIP INVITE message sent to the trunk will contain PPI
(P-Preferred-Identity) header. The default setting is "No".
Note:
"Send PPI Header" and "Send PAI Header" cannot be enabled at the
same time. Only one of the two headers is allowed to be contained in the
SIP INVITE message.
If enabled, the SIP INVITE message sent to the trunk will contain PAI
(P-Asserted-Identity) header. The default setting is "No".
Note:
"Send PPI Header" and "Send PAI Header" cannot be enabled at the
same time. Only one of the two headers is allowed to be contained in the
SIP INVITE message.
Select to enable outbound proxy in this trunk. The default setting is "No".
When outbound proxy support is enabled, enter the IP address or URL of
the outbound proxy.
Configure where to get the destination ID of an incoming SIP call, from
SIP Request-line or To-header. The default is set to "Request-line".
Configure the default DTMF mode when sending DTMF on this trunk.
Default: The global setting of DTMF mode will be used. The global
•
setting for DTMF Mode setting is under web UI->PBX->SIP
Settings->ToS.
RFC2833: Send DTMF using RFC2833.
•
Info: Send DTMF using SIP INFO message.
•
Inband: Send DTMF using inband audio. This requires 64 bit codec,
•
i.e., PCMU and PCMA.
Auto: Send DTMF using RFC2833 if offered. Otherwise, inband will
•
be used.
If enabled, the UCM6510 will regularly send SIP OPTIONS to the device
to check if the device is still online. The default setting is "No".
When "Enable Qualify" option is set to "Yes", configure the timeout (in ms)
for the Qualify SIP message. If no response is received within the timeout,
the device is considered offline. The default setting is 1000ms.
UCM6510 IP PBX User Manual
Page 167 of 317