Table 37: Iax Extension Configuration Parameters - Features - Grandstream Networks UCM6510 User Manual

SIP Settings
Max Number of Calls
Require Call Token
SRTP
Fax Mode
Strategy
Codec Preference
Call Transfer
Call Forward Unconditional
CFU Time Condition
Firmware Version 1.0.2.5
Configure the maximum number of calls allowed for each remote IP
address.
Configure to enable/disable requiring call token. If set to "Auto", it might
lock out users who depend on backward compatibility when peer
authentication credentials are shared between physical endpoints. The
default setting is "Yes".
Enable SRTP for the call. The default setting is disabled.
Select Fax Mode. The default setting is "None".
None: Disable Fax. This is the default setting.
•
Fax Detect: Fax signal from the user/trunk during the call can be
•
detected and the received Fax will be sent to the Email address
configured for this extension. If no Email address can be found for the
user, the Fax will be sent to the default Email address configured in
Fax setting page under web UI-­>PBX-­>Internal Options-­>Fax/T.38.
This option controls how the extension can be used on devices within
different types of network.
Allow A ll
Device in any network can register this extension.
Local Subnet Only
Only the user in specific subnet can register this extension. Up to
three subnet addresses can be specified.
A Specific IP A ddress
Only the device on the specific IP address can register this extension.
The default setting is "Allow A ll".
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-­G.726-­32, G,726, G.722, G.729, G.723,
ILBC, A DPCM, H.264, H.263 and H.263p.
Table 37: IAX Extension Configuration Parameters – Features
Configure the Call Forward Unconditional target number. If not
configured, the Call Forward Unconditional feature is deactivated. The
default setting is deactivated.
Select time condition for Call Forward Unconditional. CFU takes effect
only during the selected time condition. The available time condition are
"Office Time", "Out of Office Time", "Holiday", "Out of Holiday", "Out of
Office Time or Holiday" and "Specific".
Note:
UCM6510 IP PBX User Manual Page 120 of 317