Strategy
Skip Trunk A uth
Codec Preference
BATCH
A DD
I AX
E XTENSIONS
Under Web GUI->PBX->Basic/Call Routes->Extensions, click on "Batch Add Extensions"->"Batch Add
IAX Extensions".
General
Start Extension
Create Number
Permission
Firmware Version 1.0.2.5
configured for this extension. If no Email address can be found for the
user, the Fax will be sent to the default Email address configured in
Fax setting page under web UI->PBX->Internal Options->Fax/T.38.
Note:
If enabled, Fax Pass-through cannot be used.
This option controls how the extension can be used on devices within
different types of network.
Allow A ll
•
Device in any network can register this extension.
Local Subnet Only
•
Only the user in specific subnet can register this extension. Up to three
subnet addresses can be specified.
A Specific IP A ddress.
•
Only the device on the specific IP address can register this extension.
The default setting is "Allow A ll".
If enabled, users will not need enter the "PIN Set" required by the outbound
rule to make outbound calls. The default setting is "No".
Select audio and video codec for the extension. The available codecs are:
PCMU, PCMA, GSM, AAL2-G.726-32, G.722, G.729, G.723, ILBC,
ADPCM, LPC10, H.264, H.263 and H.263p. In the selected codec list,
users can click on UP or DOWN arrow to adjust the order for the codec
priority.
Table 44: Batch Add IAX Extension Parameters
Configure the starting extension number of the batch of extensions to be
added.
Specify the number of extensions to be added. The default setting is 5.
Assign permission level to the user. The available permissions are
"Internal", "Local", "National" and "International" from the lowest level to
the highest level. The default setting is "Internal".
Note:
Users need to have the same level as or higher level than an outbound
rule's privilege in order to make outbound calls from this rule.
UCM6510 IP PBX User Manual
Page 130 of 317
Need help?
Do you have a question about the UCM6510 and is the answer not in the manual?
Questions and answers