Iax Settings/Static Defense; Table 88: Iax Settings/Static Defense - Grandstream Networks UCM6510 User Manual

Auto Kill
Authentication Debugging
Codec Priority
Type of Service
IAX Trunk Options
Trunk Frequency
Trunk Time Stamps
IAX S ETTINGS/STATIC D EFENSE
Call Token Optional
Max Call Numbers
Max Unvalidated Call Numbers Configure the maximum number of unvalidated calls for all IP addresses.
Call Number Limits
IP or IP Range
Firmware Version 1.0.2.5
If set to "yes", the connection will be terminated if ACK for the NEW
message is not received within 2000ms. Users could also specify number
(in milliseconds) in addition to "yes" and "no". The default setting is "yes".
If enabled, authentication traffic in debugging will not show. The default
setting is "No".
Configure codec negotiation priority. The default setting is "Reqonly".
Caller
•
Consider the callers preferred order ahead of the host's.
Host
•
Consider the host's preferred order ahead of the caller's.
Disabled
•
Disable the consideration of codec preference all together.
Reqonly
•
This is almost the same as "Disabled", except when the requested
format is not available. The call will only be accepted if the requested
format is available.
Configure ToS bit for preferred IP routing.
Configure the frequency of trunk frames (in milliseconds). The default
setting is 20.
If enabled, time stamps will be attached to trunk frames. The default setting
is "No".
Table 88: IAX Settings/Static Defense
Enter a single IP address or a range of IP addresses for which call token
validation is not required. For example:
11.11.11.11
11.11.11.11/22.22.22.22.
Configure the maximum number of calls allowed for a single IP address.
Configure to limit the number of calls for a give IP address of IP range.
Enter the IP address or a range of IP addresses to be considered for call
number limits. For example:
11.11.11.11
11.11.11.11/22.22.22.22.
UCM6510 IP PBX User Manual Page 261 of 317