Time Settings; Auto Time Updating; Table 19: Auto Time Updating - Grandstream Networks UCM6510 User Manual

TIME S ETTINGS
AUTO T IME U PDATING
The current system time on the UCM6510 is displayed on the upper right of the web page. It can also be
found under web GUI-­>Status-­>System Status-­>General.
To configure the UCM6510 to update time automatically, go to web GUI-­>Settings-­>Time Settings-­>
Auto Time Updating.
Note:
The configurations under Web GUI-­>Settings-­>Time Settings-­>Time Auto Updating page require
reboot to take effect. Please consider configuring auto time updating related changes when setting up the
UCM6510 for the first time to avoid service interrupt after installation and deployment in production.
Remote NTP Server
Enable DHCP Option 2
Enable DHCP Option 42
Time Zone
Firmware Version 1.0.2.5
Table 19: Auto Time Updating
Specify the URL or IP address of the NTP server for the UCM6510 to
synchronize the date and time. The default NTP server is
ntp.ipvideotalk.com.
If set to "Yes", the UCM6510 is allowed to get provisioned for Time Zone
from DHCP Option 2 in the local server automatically. The default setting is
"Yes".
If set to "Yes", the UCM6510 is allowed to get provisioned for NTP Server
from DHCP Option 42 in the local server automatically. This will override
the manually configured NTP Server. The default setting is "Yes".
Select the proper time zone option so the UCM6510 can display correct
time accordingly.
If "Self-­Defined Tome Zone" is selected, please specify the time zone
parameters in "Self-­Defined Time Zone" field as described in below option.
UCM6510 IP PBX User Manual Page 72 of 317