Configuring Security Access Levels For The Scopia Elite Mcu - RADVision Scopia Elite 5100 Series Installation Manual

Configuring Security Access Levels for the SCOPIA Elite MCU

The SCOPIA Elite MCU offers configurable security access levels that enable and disable SSH, FTP,
SNMP and ICMP (ping) protocols.
By default, the security access level is set to Standard. It is recommended to set your security
access level to Maximum (which disables these protocols), except for the following situations:
Note:
Procedure
Step 1
Access the MCU security settings by selecting Configuration > Setup.
Step 2
Locate the Security section.
Step 3
Select the access level from the Security Mode list (see
the protocol status when each security access level is applied.
Table 5-2
Security Access
Level
Standard
High
Maximum
Step 4
Select Apply.
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
•
If you are performing either debugging or troubleshooting operations, SSH should be enabled.
•
If you are customizing your language settings, FTP should be enabled.
•
If you would like control or error response messages to be sent, ICMP (ping) should be enabled.
•
If you are performing configuration procedures or would like to receive traps, SNMP should be
enabled.
You can view trap events in the Events tab of the web user interface.
Figure 5-20
MCU Security Access Levels
SSH
Enabled
Disabled
Disabled
Figure 5-20 on page
Security Access Level Settings
FTP SNMP
Enabled Enabled
Disabled Enabled
Disabled Disabled
51). Table 5-2
ICMP (ping)
Enabled
Enabled
Disabled
Performing the MCU Initial Configuration | 51
lists