Subaru 2009 IMPREZA Service Manual page 1479

Diagnostic Procedure with Diagnostic Trouble Code (DTC)
ENGINE (DIAGNOSTICS)
Step
1 CHECK FRONT OXYGEN (A/F) SENSOR
CONNECTOR AND COUPLING CONNEC-
TOR.
2 CHECK HARNESS BETWEEN ECM AND
FRONT OXYGEN (A/F) SENSOR CONNEC-
TOR.
1) Turn the ignition switch to OFF.
2) Disconnect the connectors from ECM and
front oxygen (A/F) sensor.
3) Measure the resistance of harness between
ECM and front oxygen (A/F) sensor connector.
Connector & terminal
(B135) No. 9 — (E22) No. 1:
(B135) No. 8 — (E22) No. 3:
3 CHECK POOR CONTACT.
Check for poor contact of the front oxygen (A/F)
sensor connector.
Check
Has water entered the connec-
tor?
Is the resistance less than 1 ? Go to step 3.
Is there poor contact of front
oxygen (A/F) sensor connec-
tor?
EN(H4DOTC)(diag)-258
Yes No
Completely Go to step 2.
remove any water
inside.
Repair the harness
and connector.
NOTE:
In this case, repair
the following item:
• Open circuit in
harness between
ECM and front oxy-
gen (A/F) sensor
connector
• Poor contact of
coupling connector
Repair the poor Replace the front
contact of front oxygen (A/F) sen-
oxygen (A/F) sen- sor. <Ref. to
sor connector. FU(H4DOTC)-48,
Front Oxygen (A/F)
Sensor.>