5
Remove the new Second Bias
Transfer Roll unit from its box and
insert it into the machine.
6
Place the unit in the machine,
aligning the arrow indicators.
7
Fasten the unit into position by
rotating the screws clockwise.
8
Close the side cover.
9
Select [Reset Counter] on the screen.
10
Select [Yes] on the screen to reset the counter.
Replacing the Fuser Unit
The fuser unit lasts approximately 100,000 copies and prints. The machine will display
a warning message approximately 1,500 copies and prints before the unit reaches the
end of its life. Another message will be displayed when the unit needs to be replaced.
CAUTION
Fuser Safety
When removing the fuser unit, always switch off first and wait for 30 minutes until
it cools off.
Replacing Consumables
51
3