Installation When Using Usb Port; Step 1 Preparations; Step 2 Configuration On The Machine - Xerox DocuCentre-III C4100 Manual

Installation When Using USB Port

This section describes how to install the machine by using an USB interface.
The following shows the reference section for each item.

Step 1 Preparations................................................................................................................... 227

Step 2 Configuration on the Machine ...................................................................................... 227

Step 3 Configuration on the Computer .................................................................................... 228
CentreWare Internet Services Setting Items ............................................................................ 228
Step 1 Preparations
Prepare the following items to install the machine when using a USB interface.
USB cable
CD-ROM of the Driver CD Kit (provided with the machine)
USB port (optional)
Adobe PostScript 3 Kit (optional) - this is required only when using a Macintosh
computer
Step 2 Configuration on the Machine
The following describes the configuration procedure to use a USB interface on the
machine. For more information, refer to "USB" (P.134)
Note • To print binary data by using a USB interface, set [Adobe Communication Protocol] to
The configuration can also be performed using CentreWare Internet Services. For the items that can be
configured using CentreWare Internet Services, refer to "CentreWare Internet Services Setting Items"
(P.228).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or a keyboard,
and select [Enter].
When a passcode is required, select [Next Input] and enter the system
administrator's passcode, then select [Enter].
Note • The default user ID is "11111".
• The default passcode is "x-admin".
3) Select [Tools].
2
Enabling the USB port on the machine.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [USB], and select [Change Settings].
4) Select [Port Status], and select [Change Settings].
5) Select [Enabled], then select [Save].
3
Configure other USB settings as necessary.
[RAW].

Installation When Using USB Port

7
227