Xerox DocuCentre-III C4100 Manual page 351

Cause
The slave file server is not
configured. ([Bindery
Service] mode)
The slave file server
configuration is mismatched.
([Bindery Service] mode)
The form number on the print
data and the form number
set to the printer do not
match.
The level settings for the IPX
checksum do not match.
The level settings for the
NCP packet signature do not
match.
The default device name is
incorrect.
The directory tree name is
not configured.
The context is not set.
Check point
Use PCONSOLE from a
computer to confirm if the
slave file server is registered
to [Service NetWare Server]
on the print server indicated
by [Print Server
Information].*
Use PCONSOLE from a
computer to confirm if the
printer type is set to [Defined
Elsewhere] under [Print
Server Information] >
[Printer] > [Printer xxx
Environment Settings].*
Use NWADMIN on a
computer to select the
machine and confirm that the
start number of the form in
the environment setting
matches the number in the
print data.*
Use the set command from
the console screen on the
file server and confirm
whether the IPX checksum is
set to level 2.
Use the set command from
the console screen on the
file server and confirm
whether the NCP packet
signature is set to level 3.
Print out either
[Configuration Report] to
confirm the last 6 digits (3
bytes) of the Ethernet
address.
Print out [Configuration
Report] to confirm if the tree
name is specified.
Print out [Configuration
Report] to confirm if the
context is specified.
Network-related Problems
Remedy
Use PCONSOLE from a
computer to register the
slave file server and
propagate the configuration
parameters.
If not set to [Defined
Elsewhere], change to
[Defined Elsewhere] and
propagate the configuration
parameter.*
Use NWADMIN from a
computer to match the [Start
Form] number in the
machine's environment
setting to the number in the
print data.*
Enter the following command
from the console screen on
the file server to set the IPX
checksum to either level 0 or
level 1.
set Enable IPX Checksum=x
(x = 0 or 1)
Enter the following command
from the console screen on
the file server to set the NCP
packet signature to either
level 0, 1, or 2, and restart
the file server. set NCP
Packet Signature Option=x
(x = 0, 1, or 2)
Set the device name using
the correct Ethernet address.
Set the device name
different from the default
name.
Set the tree name.
Set the context.
349
14