Stapler Faults - Xerox DocuCentre-III C4100 Manual

14 Problem Solving

Stapler Faults

The following describes stapler troubles when the finisher (optional) is installed.
Follow the procedures on the following pages when copies are not stapled or staples
are bent. Contact our Customer Support Center if the problem persists after you have
tried the following solutions.
If copies are stapled as shown in the figures below, contact our Customer Support
Center.
14
438
Unstapled
One side of staple rising up
Flattened staple
Staple rising up with
Bent staple
Staple bent in reverse direction
Entire staple rising up
center pressed in