Xerox DocuCentre-III C4100 Manual page 325

Symptom
Paper is often Is the paper loaded correctly
jammed or in the tray?
wrinkled.
Is the paper tray inserted
correctly?
Is the paper damp?
Is the paper curled?
Are the paper and paper
tray settings correct?
Are there any torn pieces of
paper remaining or is there
a foreign object in the
machine?
Is non-standard paper
loaded in the tray?
Is paper exceeding the
maximum fill line in the tray?
Are the paper guides set
correctly?
Is the image nearly the
same size as the paper?
Is the paper finely cut out?
A document is Is the document small?
not fed into the
document
feeder.
An error Check the positions of the
message paper guides of the Tray 5
appears after (Bypass).
paper is loaded
in the Tray 5
(Bypass) and the
<Start> button is
pressed.
Cause
Load the paper correctly.
Refer to "Loading Paper" (P.29).
Firmly push in the paper tray as far as
possible to insert it correctly.
Refer to "Loading Paper" (P.29).
Replace the paper with new one.
Refer to "Loading Paper" (P.29).
Turn over the paper in the tray, or replace
the paper with new one.
Refer to "Loading Paper" (P.29).
Correctly load the paper into the paper
tray.
Refer to "Changing the Paper Settings" (P.36).
Open the door of the machine or slide out
the paper tray to remove the torn pieces or
the foreign object.
Refer to "Paper Jams" (P.427), or "Loading
Paper" (P.29).
Replace with paper that meets machine
specifications.
Refer to "Paper Types" (P.26), or "Loading
Paper" (P.29).
Load paper in the paper tray so that it does
not exceed the maximum fill line.
Refer to "Loading Paper" (P.29).
Load the paper correctly, and align the
paper guides with the paper gently.
Refer to "Loading Paper" (P.29), or "Changing
the Paper Size for the Trays" (P.34).
Increase the edge erase widths.
For more information, refer to "3 Copy" in the
User Guide when you make copies, or to the
print driver's online help when you print data.
Some types of paper may not be cut out
finely. Load the paper after fanning it well.
The minimum size of the document that
can be loaded on the document feeder is
139.7 x 210 mm (A5, A5 , 5.5 x 8.5, 5.5 x
8.5 ).
Refer to "3 Copy" > "Copying Procedure" in
the User Guide.
Adjust the paper guides to the correct
positions.
Refer to "Loading Paper in the Tray 5
(Bypass)" (P.30).
Machine Trouble
Remedy
323
14