Xerox DocuCentre-III C4100 Manual page 466

15 Appendix
Setting Item
Form overlay
Stapling
Bypass Tray -
Wait User
Punching
Number of holes
Binary character
strings
0 Style
15
Number of sets
464
Item
Number
64 Constantly performs Form Overlay by selecting a form name (No. 01-64)
registered on the machine.
[0] (Default)
[1-64]
Important •Since this setting selects the default value, it is not affected when an
extended commend is received.
•Once a form name is selected, it will remain displayed even if the
form is deleted. When a form name is selected using the up and
down arrow keys, it will not be displayed. In this case, the setting is
set to "Off".
66 Sets the stapling position.
[0] (Default)
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
67 Sets whether to suspend the print processing when feeding paper from
Bypass Tray. The processing is resumed by a user operation on the
machine.
[0]
[1] (Default)
69 Select the position for punching.
[0] (Default)
[1]
[2]
[3]
[4]
70 Select the number of punch holes.
[0] (Default)
[1]
72 Sets the specified character strings when entering commands in
hexadecimal format.
[0] (Default)
[1]
[2]
73 Sets the typeface for "0".
[0] (Default)
[1]
74 Sets which value to use as the number of print sets.
[0]
[1]
[2] (Default)
Value
: Off
: No. 1 - No. 64
: Off
: Top left
: Top Double
: Top Right
: Left Double
: Right Double
: Bottom Left
: Bottom Double
: Bottom Right
: Off
: On
: Off
: Top
: Bottom
: Left
: Right
: 2 holes
: 3 holes
: Off
: &$%$
: $?!#
: 0
:
: Protocol
: Panel
: Command