Configuration Of Job Flow Sheets; Step 1 Enabling Ports And Setting Tcp/Ip - Xerox DocuCentre-III C4100 Manual

9 Scanner Environment Settings

Configuration of Job Flow Sheets

This section describes how to configure the machine to use the Job Flow Sheets
service.
The following shows the reference section for each item.

Step 1 Enabling Ports and Setting TCP/IP................................................................................258

Step 2 Configuring the SNMP Port...........................................................................................259
Step 3 Configuration on the Computer .....................................................................................259
Step 1 Enabling Ports and Setting TCP/IP
In order to use the Job Flow Sheets service, enable the SOAP, SNMP, and Internet
Services (HTTP) ports, and then set an IP address and the other addresses. The
procedure for setting the machine is as follows.
Note
For information on how to use CentreWare Internet Services, refer to "CentreWare Internet Services
Settings" (P.215).
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or a keyboard,
and select [Enter].
When a passcode is required, select [Next Input] and enter the system
administrator's passcode, then select [Enter].
Note
3) Select [Tools].
2
Enable the SOAP port.
9
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [SOAP] and then select [Change Settings].
4) Select [Port Status] and select [Change Settings].
5) Select [Enabled] and then select [Save].
6) Select [Close].
3
Enable the SNMP port.
1) Select [SNMP] and then select [Change Settings].
2) Select [Port Status] and select [Change Settings].
3) Select [Enabled] then select [Save].
4) Select [Close].
5) Enable the Internet Services port as above.
6) Select [Close] repeatedly until the [Tools] screen is displayed.
4
Set an IP address and the others.
If an IP address is already set, this step is not necessary. If DHCP or BOOTP is
available in your environment, configure the method for obtaining the addresses. If an
258
• The configuration can also be performed using CentreWare Internet Services.
• The default user ID is "11111".
• The default passcode is "x-admin".