Print Features Overview - Xerox DocuCentre-III C4100 Manual

7 Printer Environment Settings

Print Features Overview

This machine can be set up as a local printer by directly connecting the machine to a
computer using a USB interface cable. Similarly, it can be set up as a network printer
by connecting the machine to a network.
Enable the necessary port using the control panel or CetreWare Internet Services.
7
Using the Machine as a Local Printer
Use a USB interface cable to directly connect the machine to a computer.
For more information on how to set up the machine using USB connection, refer to "Installation When
Using USB Port" (P.227).
Using the Machine as a Network Printer
To set up the machine as a network printer, the following methods are available to
connect the machine.
LPD
Use TCP/IP protocol when direct communication with the machine can be established.
For more information on how to set up the machine using LPD, refer to "Installation When Using TCP/
IP (LPD/Port 9100)" (P.229).
NetWare
The machine supports PServer mode using Netware directory service and bindery
service. The PServer mode enables the machine to function as a printer server, and to
capture print jobs in the print queue to output. The created printer for the machine
consumes one user license of the file server.
Note
224
Via Internet
IPP
Network connection
LPD/ SMB/ Port9100/ EtherTalk
Network connection
NetWare/ Windows shared printer
Server
• The machine does not support RPrinter (Remote Printer) mode.
• You can use the machine as a printer in a NDPS environment by using a Novell NDPS
Gateway. When using in a NDPS environment, settings of the machine to be used under a
NetWare print environment are required. Or, you need to enable LPD in advance and set it
as a gateway destination in a Novell NDPS Gateway setup. However, attribute information
that can be set or captured by NDPS is not supported.
Local connection
USB