Tandem Tray Module (Ttm) - Xerox DocuCentre-III C4100 Manual

2
Load paper with the side to be
copied or printed on face down,
and insert the paper lightly along
the paper guides until it comes to a
stop.
Important • Do not load mixed paper types
• Do not load paper exceeding
• When loading envelopes, make sure the flaps are closed and that the envelopes are
• When making copies or prints
• Depending on the type of the
3
Adjust the paper guides to just
touch the edges of the paper
loaded.
4
Select a copy or print job.

Tandem Tray Module (TTM)

The Tandem Tray Module allows you to load larger amounts of paper. It consists of two
trays.
Note • You cannot load custom size paper into the Tandem Tray Module.
1
Pull out Tray 2 or Tray 3 of the TTM.
The elevator in the tray lowers.
2
Place the paper stock tightly against
the left rear corner of the tray.
Note • Do not load paper above the
Note • Always load paper into the tray
3
Close the tray.
The elevator rises and positions the paper for use.
into the tray.
the maximum fill line. It may
cause paper jams or machine
malfunctions.
oriented on the tray so that the flaps will enter the machine first. However, when loading C5-
size envelopes, set the long edge feed so that the edge with the flaps is facing towards you.
on thick-stock paper and the
paper will not feed into the
machine, apply a curl to the
paper as shown in the figure
on the right. Note, however,
that excessively bending or
folding the paper may cause
paper jams.
paper, paper may not be fed
to the machine or image
quality may deteriorate.
maximum fill line.
in the orientation shown in the
diagram.
Loading Paper
2
31