Notes And Restrictions For Using Smb - Xerox DocuCentre-III C4100 Manual

15 Appendix
Settings from the control panel
Before using mail scanning, set the maximum data size for sending e-mail on the
control panel. Refer to the ISP guidelines for the maximum limit. Recommended value
is 1 to 2 MB.
In the System Administration mode, select [Tools] > [System Settings] > [E-Mail/
Internet Fax Service Settings] > [E-Mail Control] > [Maximum Total Data Size] to
perform the setting.
For more information, refer to "Maximum Total Data Size" (P.173).
The following shows adequate image sizes:
Note
Settings from CentreWare Internet Services
For settings to be performed on CentreWare Internet Services, refer to "Setting Items
Using CentreWare Internet Services" (P.219).
Important • Set [POP3 Server Check Interval] to 10 minutes or longer when connecting ISP.

Notes and Restrictions for Using SMB

The following are the notes and restrictions for using SMB.
Configuration on the Machine
Configuration on a Computer
15
Switching Off the Power
Check the following points when switching off the machine.
500
A4 full-color 200dpi with standard compression : around 700 KB
A4 full-color 200dpi with high compression
A4 black-white 200dpi (text document)
A4 black-white 200dpi (text & photo document) : around 200 KB
• The sizes described above are those for sending e-mail. The actual size may be different.
IP addresses are managed throughout the system as a whole. The configuration
should be performed only after consulting with your network administrator.
Subnet Mask and Gateway addresses may be necessary depending on the network
environment. Confirm with the network administrator and set up the necessary items.
When the port status is set to [Enable], it sometimes automatically switches to
[Disable] if the machine has insufficient memory. If this happens, either set an
unused port to [Disable], or adjust the assigned memory size.
Adjust the receiving buffer [SMB] size according to usage. When the receiving buffer
[SMB] size is smaller than the transmitted data, the machine may not be able to
receive the data.
IP addresses are managed throughout the system as a whole. The configuration
should be performed only after consulting with your network administrator.
When [Receiving Buffer - SMB] is set to [Spool to Memory].
All print data spooled within the machine memory, including the data which is being
printed is erased. The print data will not be found when the machine is powered on
again.
: around 400 KB
: around 25 KB