15 Appendix
Document: Auto, Coordinate Origin: 0 Degrees, Scaling Mode: Paper Size,
Scaling: OFF
Document: Auto, Coordinate Origin: 0 Degrees, Scaling Mode: Active Coordinate
Area, Scaling: ON
Active Coordinate Area determined by entered data
Document: Auto, Coordinate Origin: 0 Degrees, Scaling Mode: Active Coordinate
Area, Scaling: OFF
15
Active Coordinate Area determined by entered data
9. HP-GL/2 Emulation Mode Restriction
Using HP DJ750C, which is the emulation target for the HP-GL/2 emulation mode, sets
lines to a round joint if the lines are 0.35mm width or under. A miter joint is not set.
However, using the HP-GL/2 emulation mode of DocuCentre-III C3100 always sets
lines to a miter joint as a default regardless of the line width.
To cancel the default, use a command.
488
Document Size
Print Area
Paper Size
Print Area
Paper Size
Print Area
Paper Size