Advanced Settings - Xerox DocuCentre-III C4100 Manual

Color Mode 105

Advanced Settings

Auto Layout 106
Active Palette 107
No. of Prints 108
Output Tray 109
Two-Sided 110
Printing
Chinese Fonts 111
Alphanumeric 112
Fonts
Vertical Position 113
Adjustment
0 (Default): Color
1: Gray scale
2: Monochrome
Sets the color mode.
0 (Default): ON
1: OFF
Selects whether aligning the position of the document and the paper is to
be done automatically or not.
0 (Default): Command
1: Panel
Selects whether to use a pen specified by command or set on the panel.
1 250 (Default): 1): 1 - 250
-
Sets the number of prints to be made.
0 (Default): Center Output Tray
1: Side Output Tray
2: Center Output Tray - Lower
80: Finisher Tray
Sets the output tray.
0 (Default): None
1: Head to head
2: Head to toe
Sets the two-sided printing.
[None]...Prints one side.
[Head to Head]...Place the paper as in the [Paper Orientation], and it
prints both sides so that the orientation of the up-sides are aligned for
each page when the left side is closed.
[Head to Toe]...Place the paper as in the [Paper Orientation], and it prints
both sides so that the orientation of the up-sides are aligned for each
page when the top side is closed.
0: Stroke
Specifies 2-byte character fonts, including Chinese characters. The
setting cannot be changed for this model.
0: Stroke
Specifies 1 byte character fonts. The setting cannot be changed for this
model.
0 (Default): Does not move the hard clip area.
1 to 500: -250 to +250 mm
Moves the hard clip area vertically.
-1 -250 mm for setting numbers 1
to
+1 +250 mm for setting numbers 251
to
HP-GL2 Emulation
250
-
500
-
15
477