Replacing The Staple Cartridge (For Finisher-A1) - Xerox DocuCentre-III C4100 Manual

9
Remove the ring tag on the right-
hand side of the locking screw and
discard it.
10
Rotate the release lever counter-
clockwise to lock the unit into
position.
11
Close the front cover.
Note • Press firmly in the top center
12
Select [Reset Counter] on the screen.
13
Select [Yes] on the screen to reset the counter.

Replacing the Staple Cartridge (for Finisher-A1)

When the Finisher-A1 (optional) is installed and it is time to replace the staple cartridge,
a message appears on the touch screen. When this message appears, load a new
staple case into the staple cartridge.
Important • The use of staple cartridges not recommended by Fuji Xerox may impair quality and
Note • To order a staple cartridge, contact our Customer Support Center.
1
Make sure that the machine is not
operating, and open the front cover
of the finisher.
when closing the cover. If an
error message appears on the
display, press the cover on the
right-hand side to close the
cover completely.
performance. Use only staple cartridges recommended by Fuji Xerox for the machine.
Replacing Consumables
55
3